Physical Drive Hp-need-download -controller -1 Model Serial - May 2026

This will list the name (usually the drive letter), model, and serial number of all physical drives.

  • Using PowerShell:

    This does essentially the same thing as the Command Prompt example but in PowerShell.

    • Best for: Updating the firmware of HP-branded physical drives (e.g., Hynix, Toshiba, Intel SSDs). This will list the name (usually the drive

    Your search keyword correctly emphasizes model serial. Without these, you cannot find the correct download. Here is how to get them.

  • Degraded array:
  • Controller errors:
  • Boot issues after updates:

    • If you want to exclude the controller layer, use operating system commands that talk directly to the drive via the SCSI or ATA commands. Ensure you have the controller in HBA/IT mode or are using a direct SATA port.

    On Windows (PowerShell as Admin):

    Get-PhysicalDisk | Select FriendlyName, SerialNumber, Model, MediaType

    Look for entries not labeled "Virtual Disk" or "Controller Logical Drive."

    On Linux (using smartctl from smartmontools):

    sudo smartctl --scan
sudo smartctl -i /dev/sdX  # replace X with your physical drive, NOT the raid device

    Exclude controller by using /dev/sgX (SCSI generic) instead of /dev/sdX if behind a controller. Using PowerShell:

    Cause: The controller is masking the drive’s native serial number. Solution: Temporarily move the physical drive to a direct SATA port on the motherboard (if exists) or use a USB-to-SATA bridge with power pass-through. Then apply firmware.

    The -1 likely represents one of the following:

    In practice, when searching HP’s Support Center, typing:
    physical drive firmware -controller -001 will filter out legacy revisions. This does essentially the same thing as the