Nitocote Nt402 Msds Official
These properties explain why the behavior of Nitocote NT402 is predictable.
| Property | Value | | :--- | :--- | | Appearance | Viscous colored liquid | | Odor | Aromatic hydrocarbon | | pH | Not applicable (solvent-based) | | Boiling point | 138°C – 144°C (for xylene component) | | Flash point | 25°C – 32°C | | Evaporation rate | Slower than ether, faster than water (BuAc = 1) | | Vapor density | Heavier than air (vapors settle near ground) | | Solubility in water | Negligible (forms a separate layer) | | Viscosity | 800 – 1,200 cP (depending on temperature) | | VOC (Volatile Organic Compounds) | Approximately 450 – 550 g/L (very high – check local EPA limits) |
Handling:
Storage:
Nitocote NT402 is a high-performance, two-part, water-based epoxy coating manufactured by Fosroc. It is designed for the protection and beautification of concrete and masonry surfaces (e.g., bund walls, secondary containment areas, concrete floors).
The MSDS (Material Safety Data Sheet) – now commonly referred to as SDS (Safety Data Sheet) under GHS – is the critical legal document that governs how this material is handled, stored, and used. This feature breaks down the key sections of the Nitocote NT402 MSDS.
This is the section most frequently consulted by safety officers. nitocote nt402 msds
| Exposure Route | Control Measure | Recommended PPE | | :--- | :--- | :--- | | Inhalation | Local exhaust ventilation (LEV) | Half-face or full-face respirator with Organic Vapor (OV) cartridges (e.g., NIOSH approved 6001). | | Skin (Hands) | Chemical barrier | Nitrile gloves (0.4mm thickness, >480 min breakthrough time). Do not use latex or neoprene – they degrade quickly with aromatics. | | Skin (Body) | Avoid splashes | Tyvek or chemical-resistant apron. | | Eyes | Splash guard | Chemical splash goggles (not just safety glasses). | | Footwear | Spill resistance | Rubber boots with steel toe (leather absorbs solvent). |
Occupational Exposure Limits (OELs): For Xylene, the typical 8-hour TWA (Time Weighted Average) is 100 ppm (435 mg/m³) ACGIH. The MSDS will state that users should stay below these limits.
The MSDS typically classifies Nitocote NT402 as a Hazardous Chemical (depending on regional regulations). Key hazards include: These properties explain why the behavior of Nitocote
| Hazard Class | Part A (Resin) | Part B (Hardener) | |--------------|----------------|--------------------| | Skin Corrosion/Irritation | Category 2 | Category 1B/2 | | Eye Damage/Irritation | Category 2A | Category 1 (Serious) | | Skin Sensitization | May cause allergic reaction | Yes – Known sensitizer | | Aquatic Toxicity | Chronic 2/3 | Chronic 2/3 |
Key Signal Word: DANGER (primarily due to Part B)
Hazard Statements (examples):
Common ingredients in coatings like Nitocote NT402 may include: