cd /opt/ManageEngine/NetFlowAnalyzer/bin
./netflow.sh start
To enable auto-start at boot:
sudo /opt/ManageEngine/NetFlowAnalyzer/bin/netflow.sh install
You must configure your network device to export flows to the NetFlow Analyzer IP. manageengine netflow analyzer installation guide
On the NetFlow Analyzer UI:
On your Cisco router (example CLI):
configure terminal
interface GigabitEthernet0/1
ip flow ingress
ip flow egress
exit
ip flow-export source GigabitEthernet0/0
ip flow-export version 9
ip flow-export destination <NetFlowAnalyzer-IP> 2055
end
write memory
This document serves as a comprehensive guide for the installation, configuration, and initial setup of ManageEngine NetFlow Analyzer. NetFlow Analyzer is a unified bandwidth monitoring and traffic analytics tool that uses flow technologies (NetFlow, sFlow, IPFIX, etc.) to provide real-time visibility into network traffic. This guide covers system prerequisites, installation procedures for Windows and Linux environments, post-installation configuration, and initial troubleshooting. cd /opt/ManageEngine/NetFlowAnalyzer/bin
ManageEngine NetFlow Analyzer is a network traffic analysis tool that helps you monitor and analyze network traffic patterns, detect security threats, and optimize network performance. This guide will walk you through the installation process of ManageEngine NetFlow Analyzer. You must configure your network device to export
sudo systemctl start netflowanalyzer
sudo systemctl enable netflowanalyzer
cd /opt
sudo wget https://www.manageengine.com/products/netflow-analyser/linux/NetFlowAnalyzer_64bit.bin
sudo chmod +x NetFlowAnalyzer_64bit.bin