Password Full — How To Reset Multistar Dvr

Step 1 – Identify your DVR model: Look at the sticker on the bottom or back of the DVR. Find the Model Number (e.g., MDVR-04, H.265-4CH, or XVR-108). Also note the chipset if visible (Hi3516, Hi3520, etc.).

Step 2 – Obtain the universal reset firmware: Multistar devices often use a generic firmware signature. Search for:
"Multistar DVR reset password firmware" or "unlock_hik_hisec.bin" (Many clones share this method).
Alternatively, contact Multistar support at support@multistar.com with your model and serial number. Request the “factory reset firmware” or “password reset tool.”

Step 3 – Prepare the USB drive:

Step 4 – Power down the DVR: Unplug the power adapter from the DVR or the wall outlet. how to reset multistar dvr password full

Step 5 – Insert USB and boot into recovery mode:

Step 6 – Wait for the reset process: The DVR will load the firmware from the USB. This takes 2–5 minutes. Do NOT power off during this process. When complete, the DVR will reboot automatically.

Step 7 – Default credentials: After reboot, remove the USB drive. Default login is: Step 1 – Identify your DVR model: Look

Step 8 – Reconfigure your settings: You will need to set date/time, network, and recording schedules again. The old footage remains on the HDD, and you can view it immediately.

Before proceeding, please note: DVR password reset procedures can vary significantly depending on the specific model, firmware version, and hardware revision of your Multistar DVR. The methods below cover the most common scenarios for generic Multistar and rebranded DVRs (often based on generic H.264/H.265 boards).

Warning: Attempting hardware resets (Method 3) involves opening the device case, which may void your warranty and poses a risk of electrical shock. Proceed at your own risk. Step 4 – Power down the DVR: Unplug

If you have physical access to the DVR, this is the most reliable method. It forces the DVR to revert to factory settings.

What you need: A small screwdriver (Phillips head) and a pair of tweezers or a small jumper cap.

Step-by-Step:

  • Change the Jumper Position:
  • Reassemble and Power On: Put the cover back loosely, plug in the power, and turn the DVR on.
  • Login: The default credentials should now be active:

    • If none of the above methods work, the firmware on your specific unit may have a unique encryption lock.

    Note: This method requires connecting the DVR to a monitor to see the date/time string.