Gilbarco Sk700 Programming Manual May 2026

The manual dedicates an entire chapter to Intermittent Failure Analysis. Here are three common errors resolvable via programming:

| Error Code | Meaning | Programming Fix | | :--- | :--- | :--- | | E-10 | Reboot or low voltage | Reset the ECPU board; check program switch position (must be OFF after programming). | | E-PRO | Program Checksum Error | Re-enter all parameters from the manual’s "Factory Default Table." Corrupted memory requires re-flashing the EPROM. | | L. Err | Leak Detection Failure | Enter diagnostic mode (Pr 20). Adjust the leak detect sensitivity from 1 (strict) to 5 (lenient). Note: Local codes apply. | Gilbarco Sk700 Programming Manual

A genuine Gilbarco SK700 manual is structured into logical modules. Below is a breakdown of the key chapters you will encounter. The manual dedicates an entire chapter to Intermittent

  • Common checks:
  • Clear non-persistent faults after corrective action; persistent errors may require vendor support.

    • | Step | Action | |------|--------| | 1️⃣ | Connect & launch the host software (as above). | | 2️⃣ | Backup configuration. | | 3️⃣ | Go to Configuration → Nozzle Mapping. You’ll see a table: Nozzle #, Grade Code, Physical ID, Status. | | 4️⃣ | Click Add. Enter the new nozzle number, assign the correct Grade Code (e.g., “DSL” for Diesel), and set Status = Active. | | 5️⃣ | If the new nozzle is a remote (e.g., a hose from a secondary manifold), you may need to edit the I/O Mapping page to define its hardware address. | | 6️⃣ | Validate, then Upload the configuration. | | 7️⃣ | Perform a Nozzle Self‑Test from the host (Diagnostics → Nozzle Test). The software will energize the solenoid and confirm closure/opening. | | 8️⃣ | Re‑boot and confirm that the pump now displays the new grade on the affected nozzle. | Common checks:

    | Step | Action | |------|--------| | 1️⃣ | Connect a Gilbarco service cable (DB‑9 RS‑232 or Ethernet) from the dispenser’s Service Port to your laptop. | | 2️⃣ | Launch the SK‑H host application (often installed as SK_Host.exe). | | 3️⃣ | Select the target dispenser from the drop‑down list (use the pump’s Serial/Asset number). | | 4️⃣ | Backup the existing configuration: File → Export → CurrentConfig_<pump‑id>_YYYYMMDD. Store the file in a secure folder. | | 5️⃣ | Navigate to Configuration → Grade/Price Tables. You’ll see a grid with columns: Grade Code, Price (¢/gal), Tax Code, Effective Date. | | 6️⃣ | Edit the desired row(s). Example: Change “UNL” (Unleaded) from 2.849 ¢/L to 2.975 ¢/L. | | 7️⃣ | Click Validate – the software checks for overlapping price‑effective dates and required tax fields. | | 8️⃣ | Write the new configuration: File → Upload → CurrentConfig. Confirm the prompt (“Are you sure you want to write to dispenser #123?”). | | 9️⃣ | Reboot the dispenser (soft‑reset via the host or power‑cycle the unit). | | 🔟 | Verify on the pump screen that the new price appears, then run a Test Transaction in Service Mode to ensure the price calculation is correct. |