| Problem | Likely Fix | |---------|-------------| | Drive not detected | Use a USB 2.0 port; disable USB 3.0; run as Admin | | "Not supported controller" | Wrong tool version – try v19.x or v14.x | | Error code 0x10 / 0x11 | Bad flash chip or incompatible tool | | Windows doesn't see drive after MP | Replug device; open Disk Management and initialize |
| Error Code | Meaning | Solution | |------------|---------|----------| | 0x01 | NAND not supported | Try newer AlcorMP version or manually select NAND type. | | 0x02 | Bad block count too high | NAND is failing – tool will likely fail; discard drive. | | 0x03 | Firmware mismatch | Extract firmware (.fw or .bin) from another drive or find correct firmware pack. | | 0x06 | CID write fail | Reinstall driver, disable signature enforcement, run as admin. | | 0x0E | Timeout during test | Drive connection unstable – try different USB port (USB 2.0 preferred). | alcor micro au6989sn-gtc software
The AlcorMP software offers advanced features often used by OEMs: | Problem | Likely Fix | |---------|-------------| |
The primary software is called AlcorMP. It communicates directly with the AU6989 chip to: The AlcorMP software offers advanced features often used
| Tool | For AU6989SN-GTC? | Difficulty | Risk | |------|------------------|------------|------| | AlcorMP | ✅ Yes | High (expert) | High | | H2testw | ❌ No (only tests) | Low | None | | Rufus / BalenaEtcher | ❌ No (won't fix bad blocks) | Low | Low | | MPTool (SMI) | ❌ Different vendor | – | – |